Fire System Panel

The main control for the fire alarm system is located in the entryway (by the ramp door). This is where alerts can be seen and cleared, a fire drill can be run, etc. The buttons on the panel are disabled unless the key is inserted and turned. There is a key kept on top of the panel itself, as well as in the Sprouts Director's Office.

If you have an alert for something like a low battery, and even after it has been replaced the alert remains, utilize the following procedure.

1. Unlock panel with key
2. Press COMMAND a few times until it says MENU
3. Choose YES via the softkey
4. Enter pin <found on ToL Login Page>, then COMMAND to confirm
5. Pres COMMAND 2 more times until you see SENSOR RESET
6. Press any softkey
7. It should say SENSORS OFF, then - without touching anything - it should change to SENSORS ON after a few seconds
8. After that, press the back key (arrow pointing to the left hand side) until you are at the main screen
9. Alerts should now be gone, and only show the day of the week and time

CONGRATS!

If you are trying to figure out an error and it refers to a specific smoke detector, you can reference the location of the detector according to its number here.